Results

KINGPIN & BUSHES SET FOR TC

KINGPIN & BUSHES SET FOR TC

Bristol (Avon) United Kingdom (September 20, 2017)

Kingpin and bushes set for a TC. Includes thrust washers and cotter pins. The kingpins are made from EN36. £85 the set, plus postage. more

TD rear hub

TD rear hub

Lincolnshire (Lincoln) United Kingdom (September 11, 2017)

MGTD rear hub mine badly worn on inner spline hoping the half shaft is harder than the hub so there is minimum wear on the half shaft more

SOLD*****FRONT SPRING PINS TA/B/C*****SOLD

SOLD*****FRONT SPRING PINS TA/B/C*****SOLD

Bristol (Avon) United Kingdom (September 9, 2017)

Pair of new front spring pins for TA/TB/TC. £30 per pair.(MOSS price is £35.60 per pair - not sure of the MOSS metal specification but mine are made from hi-spec SAE/ANSI/8620).*****SOLD*****Also available pair of tab washers for above if required. £2.50 per pair.(MOSS price is £13.20 per pair). more

MG TA original MPJG engine and gearbox for sale complete

MG TA original MPJG engine and gearbox for sale complete

Rickmansworth (Hertfordshire) United Kingdom (September 7, 2017)

4 weeks ago I acquired a 1938 TA rolling chassis with REBUILT MPJG engine & gearbox. I have acquired a supercharged XPAG engine for this Q type project and so the engine & gearbox are for sale. Engine 2385 & gearbox are understood to have been fully rebuilt and run last year. Details ava... more

NOW SOURCED***TC clutch fork required***NOW SOURCED

NOW SOURCED***TC clutch fork required***NOW SOURCED

Rickmansworth (Hertfordshire) United Kingdom (September 5, 2017)

TC clutch fork required *****NOW SOURCED***** more

Wanted  Wire wheel spinner

Wanted Wire wheel spinner

Les Andelys (Eure) France (August 26, 2017)

I am looking for one RHS 12tpi wire wheel spinner in good condition , I purchased four new ones and they are awful, so just need one to make up a set , can be sent to UK address. more

MGTD rebuilt engine complete with everything rebuilt and installed ready to run

MGTD rebuilt engine complete with everything rebuilt and installed ready to run

East Brunswick (New Jersey) United States (August 19, 2017)

Complete engine ready to install tested and run on a test stand includes from all pan to CYLINDER HEAD AS WELL AS REBUILT STARTER CARBS GENERATOR AND SERVICED DISTRIBUTOR. PLUG AND PLAY READY TO INSTALL more

Wanted - 19 inch wire wheel for TC

Wanted - 19 inch wire wheel for TC

(les Andelys) France (August 15, 2017)

One 19 inch wire wheel wanted for TC. more

NOW SOURCED***XPAG block WANTED***NOW SOURCED

NOW SOURCED***XPAG block WANTED***NOW SOURCED

Rickmansworth (Hertfordshire) United Kingdom (August 13, 2017)

WANTED XPAG block to tune up to fast road car spec for my TA Q type that I have just acquired. This will free up my reconditioned MPJG engine and gearbox.All options considered. Swap, purchase, sell. Email/ ring me with what you have/need. ***NOW SOURCED*** more

SOLD*****TA body parts for sale*****SOLD

SOLD*****TA body parts for sale*****SOLD

Rickmansworth (Hetfordshire) United Kingdom (August 8, 2017)

Complete bonnet £250Scutttle - repainted good condition £250Foot board and chassis/scuttle brackets £75Hood frame £754 Side screen frames £50Petrol tank £150Petrol tank straps £30Offside door skin rusty £15Door hinges £25 per doorVarious body timbers - some ok £50 the lotFront & rear road spring... more